BLACK 2010 YAMAHA YZ450F FRONT BRAKE LINES.

Description:

Dirt bike clear-coated hose with chrome fittings and colored, vinyl reinforcement.
Provides stronger, more progressive action than stock.
Be sure to cover up any parts that might get brake fluid on them, because brake
fluid will eat through paint.
Brake line installation.
First you�re going to unbolt the caliper, let it hang freely
and the brake lines are as straight as possible.
Drain all of the brake fluid.
Bolt the brake lines into place.
You will need the following tools to bleed your brakes

1. Wrench
2. Brake bleeding kit
3. Brake fluid overflow container
4. Shop rags
5. Brake Fluid (Make sure you have the correct kind. )
Connect the brake bleeding kit to the brake fluid nipple located on the brake caliper.
Loosen the nipple so the fluid is free to flow down the brake bleeding kit tube and into the
container.
Detach the master cylinder cap, so you can monitor and refill more brake fluid into the
master cylinder as you bleed the brakes.
Pump the brake lever so the old/new brake fluid is forced through the tube into the brake
bleeding kit fluid container.
Keep the volume of the master cylinder constant, as to not have it empty. Keep pumping on
the brake lever until the fluid coming out is clear.
Once all the tiny air bubbles are gone hold pressure on the brake level and re-tighten the
brake fluid nipple to close it off.
Replace the master cylinder top cover.
Remove the brake bleeding kit from the caliper and use the rag with water to clean up any
spillage.

Yamaha YZ450F 2010 Dirt Bike Front Brake Line